Keypad Operation; Home Screen Display Selection - YASKAWA GA700 Series Technical Manual

4.6

Keypad Operation

◆

Home Screen Display Selection

This section gives information about the content shown on the HOME screen and the functions that you can
control from the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
• To change what the screen shows, change the setting for o1-40 [Home display selection].
• When o1-40 = 0 [Home Screen Display Selection = Custom Monitor], and there is more than one screen, use
or to switch between screens.
■
JOG Operation
Push to illuminate
motor.
■
Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when operating the drive from the keypad. Push
.
Push and hold [FWD/REV] to toggle the direction of motor rotation between forward and reverse.
■
Show the Standard Monitor
Push to show the standard monitor (Ux-xx). When you push
home screen.
Note:
When a fault, minor fault, or an error occurs, push
(Ux-xx).
■
Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
2. Push or to select the digit to change, then push
3. Push to keep the changes.
YASKAWA SIEPC71061705H GA700 Series Technical Manual
. Push and hold [JOG] to run the motor. Release
to show the content of the fault. Push

4.6 Keypad Operation

[HOME], the keypad goes back to the
again to show the standard monitor
or to change the value.
[JOG] to stop the
to illuminate
4
149