Switches And Jumpers On The Terminal Board - YASKAWA GA700 Series Technical Manual

A - Connect the shield to terminal E (G) of the drive.
B - Sheath
3.
Put the cable through the clearance in the wiring cover.
4.
Install the LED status ring board, front cover, and the keypad to their initial positions.
◆

Switches and Jumpers on the Terminal Board

The terminal board has switches to adapt the drive I/Os to the external control signals as shown in
Set the switches to select the functions for each terminal.
Position Switch
A DIP switch S2
B Jumper Switch S5
DIP switch S1-1
C DIP switch S1-2
DIP switch S1-3
D DIP switch S4
YASKAWA SIEPC71061705H GA700 Series Technical Manual
Figure 3.44 Prepare the Ends of Shielded Wire
Figure 3.45 Control Circuit Wiring
Figure 3.46 Locations of Switches
Table 3.14 I/O Terminals and Switches Functions
Terminal
Enables and disables the MEMOBUS/Modbus communications
-
termination resistor.
FM, AM Sets terminals FM and AM to voltage or current output.
A1 Sets the input signal type (voltage/current).
A2 Sets the input signal type (voltage/current).
A3 Sets the input signal type (voltage/current).
A3 Sets MFAI or PTC input.
C - Insulate with electrical tape or shrink tubing.
Function
3.5 Control Circuit Wiring
Figure 3.46.
Default
OFF
FM: V (voltage output)
AM: V (voltage output)
V (voltage input)
I (current input)
V (voltage input)
AI (analog input)
3
103