Set File Type And Select Device - Keysight N9912A User Manual

File Management
Saving and Recalling Files
— Navigate to the file to be recalled using the Up/Down arrow keys.
— Then

Set File Type and Select Device

The following File TYPE and DEVICE settings are used to determine the type of
file to save, and the location to be used for all file operations.
These two settings remain through an instrument preset, but are reset to the
default values when the FieldFox power is shutdown.
Select Device (location of File Save/Recall)
— Press Save/Recall 9.
— Then
Choose from the following:
Insert only ONE USB Flash Drive in the FieldFox when saving or copying
files.
How to set File Type
State files are the only file type that can be recalled by the FieldFox.
— Press Save/Recall 9
— Then
Keysight N9912-90001 User's Guide
Recall File or Enter.
Select Device to set the LOCATION where the file is to be saved.
— Internal Saves/Recalls/to/from the FieldFox internal memory. To
specify a folder, first select Manage Folders (learn how in
Folders" on page 17-8). The Data Link software will read data ONLY
from the \UserData folder.
— SD Card Saves/Recalls/Moves (Copies) files to/from the SD card (not
included), inserted in the card slot. See
page 2-7. Only the root folder is available.
— USB Saves/Recalls files to or from a USB Flash drive (not included)
that is inserted in one of the USB connectors. Only the root folder is
available.
File Type. Choose one of the following:
— State Saves ALL FieldFox instrument settings for ALL Modes to a
*.sta file. If a calibration is ON in CAT or NA Mode, calibration data is
also saved. This file can be opened ONLY by a FieldFox. State files
can be saved between compatible FieldFox models. See note in
page 17-2.
— Trace+State Saves the current trace and instrument settings to a
*.sta file. In SA Mode, all traces are saved. This file can be opened
ONLY by a FieldFox. When recalled, the FieldFox sweep is set to Hold.
"Manage
"Take the FieldFox Tour" on
17- 5