How to Set a Parameter
Keysight 81960A Compact TLS Module User's Guide
General Description
This chapter is a general description on how to set a parameter. The
following chapters only describe specific details for particular parameters.
The Modify Knob and the numerical key pad are only available on the
NOTE
8164 A/B.
•
First select the correct module using the [Channel] hard key.
•
You can switch from the Overview Screen, where you see all modules,
to the Details Screen, where the whole screen is used to show a single
module, and back using the topmost soft key. It is either labeled
"Overview" or "Details" depending on the current view.
•
Move to the parameter you want to change using the arrow keys or the
Modify Knob.
•
For some parameters you can now change the unit (e.g. W dBm for
power) or switch between frequency and wavelength using the soft
keys.
•
Press [Enter], the Modify Knob, or the [Edit] soft key to start editing the
value.
•
Enter the desired value using the Up/Down/Left/Right keys, the Modify
Knob or the numerical key pad.
•
When finished press [Enter], the Modify Knob, or the [OK] soft key. You
can also cancel the operation using the [Cancel] soft key.
Not all parameters are available in all operation modes or instrument
NOTE
states.
•
If a parameter is not displayed on the screen, it can alternatively be
accessed using the [Menu] soft key, which opens a menu with all
currently available parameters:
Operating Instructions
31
3