IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 557

Trigger Type: Selects the condition to display the Selector Switch from the following.
Always visible: The Selector Switch is always displayed.
While ON:
While OFF:
While satisfying the condition: Displays the Selector Switch when the condition is satisfied.
Data Type: Selects the type of data handled by the conditional expression for the visible condition.
This option can only be configured if While satisfying the condition is selected for Trigger Type.
For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.
Device Address: Specifies the bit device or the bit number of the word device to serve as the visible condition.
This option can only be configured when While ON or While OFF is selected for Trigger Type.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2
"5.1 Device Address Settings" on page 2-68.
Condition: Specifies the conditional expression for the visible condition.
This option can only be configured when While satisfying the condition is selected for Trigger
Type.
Click to display the Trigger Condition Settings dialog box. For the conditional expression
configuration procedure, refer to Chapter 2 "5.2 Setting Conditional Expressions" on page 2-71.
Comment: Used for entering a comment for the visible condition. The maximum number is 80 characters.
Selector Switch
state
Displays the Selector Switch when the value of device address is 1.
1
Value of
device address
0
Selector
Switch state
Hide
Displays the Selector Switch when the value of device address is 0.
1
Value of
device address
0
Selector
Switch state
Show
Satisfied
Condition
Not satisfied
Selector Switch
state
Hide
WindO/I-NV4 User's Manual
Always show
Show Hide Show
Hide Show Hide
Show Hide Show
8 Selector Switch
Show Hide
8
Hide Show
Show Hide
8-155