IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 995

11 In Label, enter the text to display for the label of the data.
The label is used for the label row of the data number columns when the data is output as CSV.
• When Number of Data is 2 or higher, "Data+Number" is automatically entered.
Example: Data001, Data002, Data003
• If the Use Text Manager check box is selected on the Data tab, specify a text ID to use for the label in
Label(Start Text ID).
12
In Top Device Address, specify the starting device address of the word devices that will be read for sampling data.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-68.
13
Select the data type of the sampled device value in Data Type.
The data type selected here is the data type for the numerical values when the data is output as CSV.
When String(S) is selected, use Words to specify the number of words of device addresses to read starting from the
set device address and proceed to step
starting device address will be output as CSV.
14
Under Display Type, set the display type for numerical values when data is output as CSV.
Counting Method
■
Select the display type as Decimal or Hexadecimal for numerical values.
Digits
■
Specifies the digits to display. The range of digits that can be set varies based on the display type and data type.
Display Floating Point
■
Select this check box to display the decimal point.
Floating Digits
■
Specifies the number of digits for the fractional part of the decimal value out of the number of digits specified by
Digits.
This option can only be configured when the Display Floating Point check box is selected.
Floating Symbol
■
Selects the decimal point symbol from the following.
.(dot), :(colon), ;(semicolon), ,(comma), /(slash)
This option can only be configured when the Display Floating Point check box is selected.
15
Click OK to close the Add Data dialog box.
You are returned to the Individual Settings dialog box.
To individually register Data Log settings, repeat steps
15
. The set number of words of consecutive device addresses from the
9 14
through .
WindO/I-NV4 User's Manual
2 Data Log Function Configuration Procedure
14
14-11