Satisfy the condition:
Command is executed when condition changes from not satisfied to satisfied.
Condition
While satisfying the condition:
The command continues being executed while the condition is satisfied.
Condition
Data Type
■
Selects the data type to be handled by the condition formula.
Can only be set if Satisfy the condition or While satisfying the condition is selected as Trigger Type.
For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.
Device Address
■
Specifies the bit device or the bit number of the word device to serve as condition.
Can only be set if Rising-edge or Falling-edge is selected as Trigger Type.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-68.
Condition
■
Sets the condition formula.
Can only be set if Satisfy the condition or While satisfying the condition is selected as Trigger Type.
Click
to display the Trigger Condition Settings dialog box. For the conditional expression configuration
procedure, refer to Chapter 2 "5.2 Setting Conditional Expressions" on page 2-71.
Comment
■
Used for entering comments about trigger conditions. The maximum number is 80 characters.
Satisfied
Not satisfied
Action
Execution
Satisfied
Not satisfied
Action
Execution
WindO/I-NV4 User's Manual
Execution
Execution Execution
1 Bit Write Command
Execution
Execution Execution
12
12-7