IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 144

5 User Communication
Inching: Commands that send data from the MICRO/I to the external device and execute inching operations of the
driving part.
This option can only be set when Enable is selected in Inching Function on the Project Settings dialog
box.
MICRO/I
HG1P
Processing of the command for the inching function is as follows:
Example: Function Key in Trigger Condition is F7, Trigger Type is While satisfying the
Condition for While satisfying
the condition in Trigger Condition
Value of Completed Device Address
3-38
Data of Inching function
Transmission
SOH K
(01h) (4Bh) (31h)
condition, Condition is LSD31==5 and Completed Device Address is LM301
When the value of the Condition LSD31 is 5 and the Function Key F7 is pressed, data is
transmitted by user communication from the MICRO/I to the external device.
When data transmission is successfully completed, the value of the Completed Device Address
LM301 changes to 1.
State in which user
communication is
not operating
transmission
ON
State of the function key
"F7"
OFF
Satisfied
Not satisfied
is LSD31==5
1
LM301
0
WindO/I-NV4 User's Manual
External device
1 SOH 0 2 CR
(01h) (30h) (32h) (0Dh)
State in which data can be
transmitted by user communication
Start
Data of Inching function
Driving part
State in which user
communication is
not operating
Complete
transmission