Table of Contents
Advertisement
6 Multi-Button
Properties of Bit Write for Multi-Functions Dialog Box
Sets the Bit Write command for the Multi-Button.
Command Name
■
Enter a name for the command. The maximum number is 20 characters.
Action Mode
■
Select the behavior of the Multi-Button from the following:
Set:
Pressing the Multi-Button writes a 1 to the bit device.
Reset:
Pressing the Multi-Button writes a 0 to the bit device.
Set & Reset:
Pressing the Multi-Button writes a 1 to the bit device.
Releasing the Multi-Button writes a 0 to the bit device.
Toggle:
Pressing the Multi-Button inverts the value of the bit device.
If the value of the bit device is 0 it changes to 1, and vice versa.
Move:
Pressing the Multi-Button writes the value in the source bit device to the value in the destination bit
device.
For details about the Action Mode, refer to "Action Mode" on page 8-4. However, Set & Reset for the
Multi-Button has the same function as Momentary for the Bit Button.
Destination Device Address
■
Specify the destination bit device.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-68.
*1
Write
■
Specify the number of bit devices (1 to 64) at the destination.
This setting is enabled only if Action Mode is set to Set or Reset. For details, refer to "Write
Source Data
■
Specifies the device address that stores the data to be written.
This setting is enabled only if Action Mode is set to Move. For details, refer to "Source Data" on page 8-6.
Device Address: Specify the source bit device.
Click
"5.1 Device Address Settings" on page 2-68.
Transfer:
Specify the number of bit devices (1 to 64) to transfer.
*1 Advanced mode only
8-114
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2
WindO/I-NV4 User's Manual
*1
" on page 8-6.
Hide quick links:
Advertisement
Table of Contents
