Properties Of Pilot Lamp Dialog Box - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

1.3 Properties of Pilot Lamp Dialog Box

This section describes items and buttons on the properties dialog box.
General Tab
●
Part Name
■
Enter a name for the part. The maximum number is 20 characters.
>>OFF Text, >>ON Text
■
Applies the text entered in the Part Name field to the Text field under the OFF or ON fields on the Registration
Text tab. This is used as the Registration Text when the lamp is OFF or ON.
To specify the Registration Text to use when the button is ON, select the Set by State check box on the
Registration Text tab. If left unchecked, the same Registration Text assigned for the OFF state is
displayed for the ON state as well.
Action Mode
■
Select the action when the part is ON.
No Flash (only ON): Displays the drawing object for the ON state when the trigger condition is satisfied.
Flash (ON + Flash): When the condition is satisfied and the value of the trigger device address is 1, the object flashes
(alternates between the drawing object for the ON and OFF states at fixed intervals). The
flashing interval can be set with the Flashing Cycle setting on the System tab of the Project
Settings dialog box.
Flash Trigger Device Address: Specify the bit device to cause the lamp to flash.
The lamp flashes when the value of the device address is 1. The
action for No Flash (only ON) applies when the value is 0.
Click to display the Tag Editor. For the device address
configuration procedure, refer to Chapter 2 "5.1 Device Address
Settings" on page 2-68.
WindO/I-NV4 User's Manual
1 Pilot Lamp
9
9-3