IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 408

1 Bit Button
*1
Write
■
Specify the number of bit devices (1 to 64) at the destination.
This setting is enabled only if Action Mode is set to Set or Reset.
Example: This fills a contiguous block of bit devices with the same value.
Action Mode: Set
Destination Device Address: M0
Write: 5
If the bit number in a word device is specified, the same value is written to same bit number of contiguous
word devices.
Action Mode: Set
Destination Device Address: D0-15
Write: 5
Source Data
■
Specifies the device address that stores the data to be written.
This setting is enabled only if Action Mode is set to Move.
Device Address: Specify the source bit device.
Click
"5.1 Device Address Settings" on page 2-68.
Transfer: Specify the number of bit devices (1 to 64) to transfer.
Example: This button writes the values in a contiguous block of bit devices to a contiguous block of device addresses
at the destination.
Device Address: LM0
Destination Device Address: M0
Transfer: 4
*1 Advanced mode only
8-6
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2
WindO/I-NV4 User's Manual
M0 1
M1 1
M2 1
M3 1
M4 1
bit
15
D0 1
D1 1
D2 1
D3 1
D4 1
LM0 1 M0 1
LM1 0 M1 0
LM2 0 M2 0
LM3 1 M3 1
bit
0