Sub Host Communication Tab - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

3 Project Settings Dialog Box

3.7 Sub Host Communication Tab

The Sub Host Communication tab is used to configure the sub host communication protocol and HMI Link Register
(LLR) addresses to use. For details, refer to Chapter 3 "6 Sub Host Communication" on page 3-87. This option can
only be configured when Sub Host Communication is selected for Function under Interface Settings on the
Communication Interface tab.
Protocol
■
Selects the protocol to use in sub host communication as MicroSmart or Modbus RTU Master.
Allocate Address Number of HMI Link Register (LLR)
■
Settings:
Device Type:
Address Number:
Bit Number:
Slave Number:
4-58
HG5G-V HG4G-V
Lists the device addresses allocated to HMI Link Registers.
Address Number: Shows the LLR address numbers (LLR 0 to LLR 63).
Device Address: Shows the device addresses allocated to LLR address numbers.
B/W: Shows the device type.
B:
W:
BWORD: Bit device in word
Selects the device type of the device address to allocate to the HMI Link Register (LLR).
Only device types that can be used are shown.
Specifies the address number of device address to allocate to the HMI Link Register (LLR).
The range that can be set varies based on the selected device type.
Specifies the bit number in a word device (0 to 15). This option can only be configured
when a word device is selected for Device Type.
Specifies the slave number of the external device for the device address to allocate to the
HMI Link Register (LLR). The range that can be specified varies based on the selected
communication driver.
WindO/I-NV4 User's Manual
HG4G HG3G-V HG3G HG2G-V
Bit device
Word device
HG2G-5F HG2G-5T HG1G HG1P