IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 960

3 Alarm Log Settings Dialog Box
Channel Tab
●
The Channel tab is used to configure the device addresses to monitor and the alarm detection condition.
Source Device Address Type
■
Selects the type of device address to monitor.
Word: Uses a word device. Device Addresses are configured per block.
Bit: Uses a bit device. Device Addresses are configured per channel.
Number of Blocks
■
Configures the Alarm Log data in block units. The number of blocks that can be set varies based on the Source
Device Address Type setting.
Word: 0 to 128
Bit: 0 to 8
1 block is composed of 16 channels. 1 device address can be monitored for each channel. The maximum
number of device addresses that can be monitored is 16 for each block.
Reference Screen
■
Select the type of reference screen from the following items.
Base Screen, Popup Screen, Not Use
The reference screen is displayed when a message is selected on the Alarm List Display or the Alarm Log Display and
the key button Ref. is pressed. It is the base screen or popup screen associated with each channel.
1. Select a message displayed
on the Alarm List Display
or the Alarm Log Display
13-16
2. Press the Key Button Ref.
REV
Time Message
Up
09:15 Motor fault
10:02 Pump1 fault Dwn
Del
10:28 High pressure
Ref.
13:02 Pump 1 fault
Key Button Ref.
WindO/I-NV4 User's Manual
The reference screen opens
REV
Time Message
Pump 1 fault Pump 1 fault Up
09:15 Motor fault
Pump 1 output low
10:02 Pump1 fault Dwn
Press Stop, check the air,
Del
10:28 High pressure then press Start.
Air Press.
Ref.
13:02 Pump 1 fault
0000
Stop Start
kg/m 2
Reference screen