Alarm List Display; How The Alarm List Display Is Used - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

7 Alarm List Display

7 Alarm List Display

7.1 How the Alarm List Display is Used

The Alarm List Display works with the Alarm Log function to display messages for active alarms and to display
multiple messages according to values of device addresses in a list.
• List currently active alarms out of the alarms configured in the Alarm Log settings
0
D0-0
0
D0-1
0
D0-3
• Display multiple messages according to values of device addresses
bit3 bit0
D0= 0001
bit3 bit0
D0= 0111
• Only one Alarm List Display or Alarm Log Display can be configured on a single screen.
• When the active alarm is displayed on the Alarm List Display, the message disappears from the list when
the alarm is recovered from regardless of the Lock/Unlock setting. To display the alarm message until it
can be checked, use the Alarm Log Display. Lock/Unlock is configured on the Channel tab in the
Alarm Log Settings dialog box.
• For the key buttons used with the Alarm List Display, refer to Chapter 8 "Alarm List Display" on page 8-96.
• The number of the message (channel when using the Alarm function) that has focus on the Alarm List
Display is stored in HMI Special Data Register LSD50.
• The information about where on the list the message that has focus is displayed, out of all the messages
displayed on the Alarm List Display, is stored in HMI Special Data Register LSD56.
10-136
HG5G-V HG4G-V
External device
1
1
1
External device
Setting 1 : 100
Setting 1 : 100
Setting 2 : 200
Setting 3 : 300
WindO/I-NV4 User's Manual
HG4G HG3G-V HG3G
MICRO/I
Current fault
Pg. Up
Pg. Dwn
Pump fault
Pg. Up
Low air pressure
Pg. Dwn
MICRO/I
bit15
Pg. Up
D0
Pg. Dwn
Pg. Up
Pg. Dwn
HG2G-V HG2G-5F HG2G-5T HG1G HG1P
Message
D0-0 : Current fault
ID1
D0-1 : Pump fault
ID2
D0-2 :
High pressure
ID3
D0-3 : Low air pressure
ID4
D0-0
Alarm occurred
D0-1
Alarm occurred
D0-3
Alarm occurred
bit3 bit0
Message
Setting 1 : 100
ID1
ID2 Setting 2 : 200
ID3 Setting 3 : 300