IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 610

1 Numerical Input
Keypad
■
Configures the keypad for entering values in the Numerical Input.
Type: According to the location where the keypad is configured, selects the type from the following.
Standard:
Popup:
Current Screen: Uses the keypad configured on the same screen as the Numerical Input.
Screen Number: Specifies the screen number of the popup screen configured as the keypad (1 to 3015).
This option can only be configured if Popup is selected for Type.
Adjust location automatically:
Coordinates X, Y:
Display Type
■
Selects the display type for the value as Decimal or Hexadecimal.
Data Format
■
Data Type:
Digits:
Display Floating Point:
If Data Type is UBIN16(W), BIN16(I), UBIN32(D), BIN32(L), BCD4(B), or BCD8(EB) and the
Display Floating Point check box is selected, a decimal value will be displayed on the Numerical Input
when a decimal value is entered on the keypad in entry mode, but an integer is written to the device
address. In display mode, source data is an integer, but the value is displayed with a decimal point added at
the number of floating digits configured for the Numerical Input.
However, if Float32(F) is selected for Data Type, both the destination data and the source data are
decimal values.
Example: When Display Type is configured as Decimal, Data Type is UBIN16(W), the Display Floating
10-4
Uses the standard keypad. The standard keypad is the keypad configured as the
popup screen for the standard keypad (screen number 3000 to 3015).
This is the keypad for the type configured by Display Type.
Uses a keypad configured as a popup screen.
Select this check box to display the popup screen configured as the keypad in a
location where it will not overlap the Numerical Input.
This option can only be configured if Standard or Popup is selected for Type.
Specifies the display location of the popup screen configured as the keypad.
With the upper-left corner of the screen as the origin, the X and Y coordinates are
the upper-left corner of the popup screen.
This option can only be configured when Standard or Popup is selected for Type
and the Adjust location automatically check box is cleared.
Specify the coordinates in 1 dot units.
X: 0 to (base screen horizontal size - 1)
Y: 0 to (base screen vertical size - 1)
Selects the type of data for the value.
For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.
Specifies the digits to display. The range of digits that can be set varies based on the
display type and data type. The digits that can be set are as follows.
Display Type
Decimal display
Hexadecimal
display
Select this check box to display the decimal point.
Point check box is selected, Digits is 5, Floating Digits is 3, and Destination Device Address is
D100
MICRO/I
12.345
12.345
WindO/I-NV4 User's Manual
Data Type
UBIN16(W), BIN16(I)
UBIN32(D), BIN32(L)
BCD4(B)
BCD8(EB)
Float32(F)
UBIN16(W)
UBIN32(D)
External device
D100:
Digits
1 to 5
1 to 10
1 to 4
1 to 8
1 to 10
1 to 4
1 to 8
12345