Properties Of Numerical Display Dialog Box - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

9.3 Properties of Numerical Display Dialog Box

This section describes items and buttons on the properties dialog box.
General Tab
●
Part Name
■
Enter a name for the part. The maximum number is 20 characters.
Display Type
■
Selects the display type for the value as Decimal or Hexadecimal.
Data Format
■
Data Type:
Digits:
Display Floating Point:
When the Display Floating Point check box is selected and UBIN16(W), BIN16(I), UBIN32(D),
BIN32(L), BCD4(B), or BCD8(EB) is selected for Data Type, the source device is an integer, but the
value is displayed with the decimal point added at the configured floating digits.
However, if Float32(F) is selected for Data Type, the source data is a decimal value.
Selects the type of data for the value.
For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.
Specifies the digits to display. The range of digits that can be set varies based on the
display type and data type. The digits that can be set are as follows.
Display Type
UBIN16(W), BIN16(I)
UBIN32(D), BIN32(L)
Decimal display BCD4(B)
BCD8(EB)
Float32(F)
UBIN16(W)
Hexadecimal display
UBIN32(D)
Select this check box to display the decimal point.
WindO/I-NV4 User's Manual
Data Type
1 to 5
1 to 10
1 to 4
1 to 8
1 to 10
1 to 4
1 to 8
9 Numerical Display
10
Digits
10-169