IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 382

1 Shapes
Round Radius
■
Specifies the rounding radius (1 to 200). However, the range that can be configured is where round radius x 2 is a
value smaller than Size W and Size H.
This option can only be configured when Curve or Straight is selected for Round Type.
Shadow
■
Selects the style of shadow attached to the rectangle from the following. This option draws the rectangle in a three-
dimensional manner.
None, Convex, Concave
This option can only be configured when 1 dot is selected for Line Width and Solid is selected for Line Type.
Coordinates
■
X, Y: Specifies the display position of the rectangle in coordinates.
With the upper-left corner of the screen as the origin, the upper-left corner of the rectangle is the X
and Y coordinates.
X:
Y:
Size
■
W, H: Specifies the size of the rectangle in width and height.
W:
H:
Place on the Top Layer
■
Select this check box to display the rectangle on the top layer. The rectangle will have precedence when other
drawings and parts are overlapping with it. For details, refer to Chapter 6 "4 Drawings and Parts Overlapping" on page
6-5.
7-10
For Curve
Round Radius
None
0 to (base screen horizontal size - 1)
0 to (base screen vertical size - 1)
(0, 0)
Y
1 to (base screen horizontal size)
1 to (base screen vertical size)
Height
WindO/I-NV4 User's Manual
For Straight
Round Radius
Convex
X
Screen
Rectangle
Width
Screen
Rectangle
Concave