Table of Contents
Advertisement
8 Selector Switch
Set:
Insert:
Remove:
Default Position:
The default knob position is fixed for these two switch types because of the return functionality.
2-Notch R-return:
2-Note L-return, 3-Notch Both-return: Ch2
• If Default Position is Ch1, Ch2, or Ch3, the position of the knob does not change even if the
value in the device address configured for the channel changes, unless the change is caused by
the buttons on the Selector Switch. If Default Position is Read from Destination Device
Address, the position of the knob changes according to the value of the device address
configured for the channel.
• When a Selector Switch is redisplayed immediately after switching the screen or when a hidden
Selector Switch is redisplayed, values are not written to the destination device addresses for the
channels.
• If the value in the device address used to determine the default knob position contains an illegal
value, the knob will be shown as follows:
- 2-Notch No-return: Ch1
- 3-Notch:
8-148
Text ID:
Shows the Text ID.
Double clicking the cell displays the Text Manager where you can change the
Text ID.
Can only be set when the Use Text Manager check box is selected.
Color:
Shows the color of the Registration Text for the channel.
Double clicking the cell displays Color Palette where you can change the Text
Color
Registers or changes the notch settings. Selecting a number that has already been registered
changes the existing notch settings.
Clicking Set displays the Notch Settings dialog box where you can configure the notch. For
details, refer to "Notch Settings Dialog Box" on page 8-149.
Inserts a notch setting entry above the currently selected position.
Select the channel number from the list where you wish to insert the notch setting and click
Insert. This displays the Notch Settings dialog box where you can configure the notch. The
notch settings at the point of insertion shift down one line. Notch settings cannot be inserted if
all channel numbers have a notch setting.
Deletes the registered notch setting from the list.
Select the channel number in the list and click Remove.
Selects the default position of the knob when the MICRO/I starts operation and the Selector
Switch is first displayed on the screen.
Ch1:
Makes Ch1 the default knob position. Writes 1 to the device address configured for Ch1,
writes 0 to the device addresses configured for the other channels.
Ch2:
Makes Ch2 the default knob position. Writes 1 to the device address configured for Ch2,
writes 0 to the device addresses configured for the other channels.
Ch3:
Makes Ch3 the default knob position. Writes 1 to the device address configured for Ch3,
writes 0 to the device addresses configured for the other channels.
Read from Destination Device Address: The position of the knob is determined by the value
Ch2
WindO/I-NV4 User's Manual
of device address.
Ch1
Hide quick links:
Advertisement
Table of Contents
