Properties Of Alarm List Display Dialog Box - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

7 Alarm List Display

7.3 Properties of Alarm List Display Dialog Box

This section describes items and buttons on the properties dialog box.
General Tab
●
Part Name
■
Enter a name for the part. The maximum number is 20 characters.
Message Settings
■
Selects the method for switching message to display.
Use Alarm Log Settings:
New Message List:
Example: When Use Alarm Log Settings is selected, the source device address (device address to monitor)
configured by the Alarm Log function is D0, and the following messages are allocated to the channels
Source device address
The active alarm messages are displayed.
Bit state of Source device address
10-138
Displays messages for the active alarms. The alarms are configured by the Alarm Log
settings.
Alarm Log Settings:
Displays the messages registered in Text Manager according to the state of bits in the
trigger device address configured on the List tab.
Message
Current fault
D0-0 : ID1
Pump fault
D0-1 : ID2
High pressure
D0-2 : ID3
Low air pressure
D0-3 : ID4
1
D0-0
0
D0-1
0
D0-2
0
D0-3
Current fault
Pg. Up
Message to display
Pg. Dwn
Display ID1
Action
WindO/I-NV4 User's Manual
Displays the Alarm Log Settings dialog box.
0 1
1 0
1 1
0 1
Pump fault Current fault
Pg. Up Pg. Up
High pressure High pressure
Low air pressure
Pg. Dwn Pg. Dwn
Display ID1, ID3,
Display ID2, ID3
ID4
If all bits in the device address are 0 or if a bit with no
associated message becomes 1, display nothing.
1 0
1 0
1 0
1 0
Current fault
Pg. Up Pg. Up
Pump fault
High pressure
Pg. Dwn Pg. Dwn
Low air pressure
Display ID1, ID2,
No message
ID3, ID4