Table of Contents
Advertisement
1 Numerical Input
When Data Over
■
These options configure the operation of the part when the value entered with the keypad exceeds the allowable
range.
These options can only be configured when the Minimum or Maximum check boxes are selected under Range.
Report: Select this check box to write 1 in the Report Device Address when the entered value or the value of the
device address to display exceeds the allowable range.
Report Device Address:
Example: If you attempt to enter "140", which is higher than the maximum of "100", or "-10", which is lower than the
minimum of "0", the value is not written and the symbol selected under Symbol to show when out of
range or Error occurs on the General tab is displayed. 1 is written to the Report Device Address LM0
under When Data Over.
Range: Value
Minimum: 0
Maximum: 100
When Data Over
Report: On
Report Device Address: LM0
When the When input value is out of range, display value near maximum or minimum check box
is selected on the General tab and a value out of range is entered, 1 is written to the Report Device
Address under the When Data Over.
10-16
Specifies the Report Device Address.
Click
to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 "5.1 Device Address Settings" on page 2-68.
Operations
and
display
Entered data
Written data
Data over notification: LM0
WindO/I-NV4 User's Manual
0
80
0
80
80
140
80
0
80
10
?????
10
10
10
1
0
10
?????
-10
1
Hide quick links:
Advertisement
Table of Contents
