IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 526

6 Multi-Button
If Download PLC Program is selected.
Source: Select the the external memory where the PLC program (ZLD Project File) to be transferred is stored: SD
Memory Card
Location:
Destination: Specify the destination PLC connected to the MICRO/I. The PLC type is configured in the Project
Settings dialog box, on the Communication Driver Network tab. For details, refer to Chapter 4 "3.4
Communication Driver Network Tab" on page 4-50.
Interface: Select the communication interface in which the MICRO/I is connecting to the download
If serial interface is selected for Interface.
Slave Number:
External Device Name:
If Ethernet is selected for Interface.
Select from the following method:
Specify External Device ID:
External Device Name: The name of the specified PLC is displayed here.
Specify IP Address:
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
8-124
*1
or USB Flash Drive.
Specify the location of the ZLD Project File(.zld). The maximum number is 247 characters.
Example: "LDR_PROGRAM.ZLD" is a ZLD Project File saved in folder "LDRDATA" of an SD
memory card or USB flash drive:
LDRDATA\LDR_PROGRAM.ZLD
destination PLC from serial interface or Ethernet. For details, refer to Chapter 4 "Interface
Configuration" on page 4-35.
Specify the slave number of the download destination PLC (0 to 31).
The name of the specified PLC is displayed here.
Specify the External Device ID (0 to 31) of the destination PLC. This is the
External Device ID number set in the Project Settings dialog box, on
the Communication Driver Network tab.
Specify the IP address and port number of the destination PLC.
WindO/I-NV4 User's Manual