Table of Contents
Advertisement
When Data Over
■
These options configure the operation of the part when the allowable range is exceeded.
These options can only be configured when the Minimum or Maximum check boxes are selected under Range.
Flash:
Select this check box to make the value flash when the displayed data exceeds the allowable range.
Report:
Select this check box to write 1 in the Report Device Address when the displayed data exceeds the
allowable range.
Report Device Address:
Example: If the value of word device of the reading source is "120," which is higher than the upper limit of "100," or
"-10," which is below the lower limit of "0," a value of 1 will be written to LM0 and the displayed numerical
value will flash.
Range: Value
Minimum: 0
Maximum: 100
When Data Over
• Flash
• Report
Destination Device Address: LM0
Specifies the Report Device Address.
Click
to display the Tag Editor. For the device address configuration
procedure, refer to Chapter 2 "5.1 Device Address Settings" on page 2-68.
Read data
50
Display
Data over
0
notification: LM0
WindO/I-NV4 User's Manual
120
90
50
120
Flashing
1
0
9 Numerical Display
-10
90
-10
Flashing
1
10
10-179
Hide quick links:
Advertisement
Table of Contents
