Properties Of Timer Dialog Box - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

7.3 Properties of Timer Dialog Box

This section describes items and buttons in the Properties dialog box.
General Tab
●
Part Name
■
Enter a name for the part. The maximum number is 20 characters.
Timer Address Number
■
Specifies the HMI timer address number (0 to 31).
The device type for the HMI timer relay is LTC. The device type where the current value is stored is LTD.
Example: When 0 is specified for Timer Address Number
HMI Timer Relay:
HMI Timer Current Value: LTD0
Unit
■
Select the unit of time from sec or 100 msec.
Preset Value
■
Select the data type to use and the enter the preset value.
The preset value is the time from when the timer starts its countdown until 1 is written to the HMI Timer Relay LTC.
Value: When selecting sec in Unit, the preset value is specified with 1 to 65535 (second units) up to a
maximum of 1092 minutes 15 seconds.
When selecting 100 msec in Unit, the preset value is specified with 1 to 65535 (100 msec units).
Device Address: Uses a value of device address.
Specify the device address.
Click
2 "5.1 Device Address Settings" on page 2-68.
LTC0
to display the Tag Editor. For the device address configuration procedure, refer to Chapter
WindO/I-NV4 User's Manual
7 Timer
12
12-61