IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 802

Micro/i operator interfaces for windo/i-nv4

Table of Contents

Enables the Calendar when the value of device address is 1.

Example: When the Not show Calendar check box is cleared under While not satisfying the

Device Address

Calendar state

Enables the Calendar when the value of device address is 0.

Example: When the Not show Calendar check box is cleared under While not satisfying the

Device Address

Calendar state

While satisfying the condition:

Enables the Calendar when the condition is satisfied.

Example: When the Not show Calendar check box is cleared under While not satisfying the

Calendar state

Selects the data type to be handled by the condition formula.

Can only be set if While satisfying the condition is selected as Trigger Type.

For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.

Device Address

Specifies the bit device or the bit number of the word device to serve as condition.

Can only be set if While ON or While OFF is selected as Trigger Type.

to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device

Address Settings" on page 2-68.

Sets the condition formula.

Can only be set if While satisfying the condition is selected as Trigger Type.

to display the Trigger Condition Settings dialog box. For the conditional expression configuration

procedure, refer to Chapter 2 "5.2 Setting Conditional Expressions" on page 2-71.

Used for entering comments about trigger conditions. Maximum number is 80 characters.

Not show Calendar

When this check box is cleared, the part image is not displayed when the condition is not satisfied.

Not satisfied

WindO/I-NV4 User's Manual

Show Quick Links

Table of Contents