Properties Of Character Input Dialog Box - IDEC MICRO/I HG4G-CJT22 F-B Series User Manual

2.3 Properties of Character Input Dialog Box

This section describes items and buttons on the properties dialog box.
General Tab
●
Part Name
■
Enter a name for the part. The maximum number is 20 characters.
Keypad
■
Configures the keypad for entering text in the Character Input.
Use as Display for Keypad
Type:
Screen Number:
Adjust location automatically: Select this check box to display the popup screen configured as the keypad in a location
*1 Advanced mode only
: Select this check box to only use the Character Input as a part to display the text
*1
entered with the keypad.
According to the location where the keypad is configured, selects the type from the
following.
Standard(Half-Width Character): Uses the standard keypad for entering half-width
Standard(Hiragana):
Popup:
Current Screen:
Specifies the screen number of the popup screen configured as the keypad (1 to 3015).
This option can only be configured if Popup is selected for Type.
where it will not overlap the Character Input.
This option can only be configured when Standard(Half-Width Character),
Standard(Hiragana) or Popup is selected for Type.
WindO/I-NV4 User's Manual
characters. The standard keypad is the keypad
configured as the popup screen for the standard
keypad. For details, refer to Chapter 5 "4.3 Standard
Keypad Popup Screen" on page 5-25.
Uses the standard keypad for entering full-width
characters. The standard keypad is the keypad
configured as the popup screen for the standard
keypad. For details, refer to Chapter 5 "4.3 Standard
Keypad Popup Screen" on page 5-25.
Uses a keypad configured as a popup screen.
Uses the keypad configured on the same screen as
the Character Input.
2 Character Input
10
10-29