IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 885

Micro/i operator interfaces for windo/i-nv4

Table of Contents

Toggles the value of the specified bit device when the trigger condition is satisfied.

If the value of the bit device is 0 it changes to 1, and vice versa.

State of condition

This function writes the value in the source bit device to the value in the destination bit device when

the trigger condition is satisfied.

State of condition

Destination Device Address

Specify the destination bit device.

to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device

Address Settings" on page 2-68.

Specify the number of bit devices (1 to 64) at the destination.

This setting is enabled only if Action Mode is set to Set or Reset.

This fills a contiguous block of bit devices with the same value.

Action Mode: Set

Destination Device Address: M0

If the bit number in a word device is specified, the same value is written to same bit of contiguous word devices.

Action Mode: Set

Destination Device Address: D0-15

Specifies the device address where the data to be written is stored.

This setting is enabled only if Action Mode is set to Move.

Device Address: Specify the source bit device.

2 "5.1 Device Address Settings" on page 2-68.

Specify the number of bit devices (1 to 64) to move.

This button writes the values in a contiguous block of bit devices to a contiguous block of device

addresses at the destination.

Device Address: LM0

Destination Device Address: M0

*1 Advanced mode only

Not satisfied

Not satisfied

Not satisfied

Not satisfied

to display the Tag Editor. For the device address configuration procedure, refer to Chapter

WindO/I-NV4 User's Manual

1 Bit Write Command

Show Quick Links

Table of Contents