IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 717

Micro/i operator interfaces for windo/i-nv4

Table of Contents

Enables the Message Display when the value of device address is 1.

Example: When While not satisfying the condition is Not display message.

Device Address

Message Display

Enables the Message Display when the value of device address is 0.

Example: When While not satisfying the condition is Not display message.

Device Address

Switching Display

While satisfying the condition:

Enables the Message Display when the condition is satisfied.

Example: When While not satisfying the condition is Not display message.

Not satisfied

Message Display

Selects the data type to be handled by the condition formula.

Can only be set if While satisfying the condition is selected as Trigger Type.

For details, refer to Chapter 2 "1.1 Available Data" on page 2-1.

Device Address

Specifies the bit device or the bit number of the word device to serve as condition.

Can only be set if While ON or While OFF is selected as Trigger Type.

to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device

Address Settings" on page 2-68.

Sets the condition formula.

Can only be set if While satisfying the condition is selected as Trigger Type.

to display the Trigger Condition Settings dialog box. For the conditional expression configuration

procedure, refer to Chapter 2 "5.2 Setting Conditional Expressions" on page 2-71.

Used for entering comments about trigger conditions. Maximum number is 80 characters.

While not satisfying the condition

Selects the operation of the part when the condition is not satisfied.

Not display message:

Not show Message Display:

The plate and flange are displayed, but the message is not displayed.

Hides the Message Display.

WindO/I-NV4 User's Manual

5 Message Display

Show Quick Links

Table of Contents