Table of Contents
Advertisement
1 Bar Chart
When Data Over
■
These options configure the operation of the part when the allowable range is exceeded.
These options can only be configured when the Minimum or Maximum check boxes are selected under Range.
Flash:
Select this check box to make the chart flash when the displayed data exceeds the allowable range.
Report:
Select this check box to write 1 in the Report Device Address when the displayed data exceeds the
allowable range.
Report Device Address: Specifies the Report Device Address.
Example: If the word device value of the reading source is "110" which is higher than the upper limit of "100" ,or
"-10" which is below the lower limit of "0", a value of 1 will be written to LM0 and the displayed bar will
flash.
Range: Value
Minimum: 0
Maximum: 100
When Data Over
Flash: Selected
Report: Selected
Report Device Address: LM0
11-10
Click
to display the Tag Editor. For the device address configuration
procedure, refer to Chapter 2 "5.1 Device Address Settings" on page 2-68.
Ch1 data
Ch2 data
Display
0
Data over notification: LM0
WindO/I-NV4 User's Manual
60
110
20
50
50
100
0
50
100
Flashing
0
1
80
10
10
-10
0
50
100
0
50
100
Flashing
0
1
Ch1
Ch2
Hide quick links:
Advertisement
Table of Contents
