Registering Constant (Character)
The received data is compared with the registered character data and the number of the matching character data is
stored in the device address.
This can be configured only when RXD is selected as Type on the Command Settings dialog box, and Registering
Constant (Character) is selected under Type on the Data Settings dialog box.
Number of Registering Constants
■
Specify the number of data of the registered character data (1 to 100).
Registering Constants
■
No.:
Shows the ID No. (1 to 100) of the character data.
Index:
Shows the Index No. of the character data.
Data:
Shows the character data.
Index
■
Specify the Index No. (0 to 65535) of the character data.
Data
■
Enter the character data (1 to 1500 bytes) to be registered. The size of a single-byte character is one byte and that of
a double-byte character is two bytes.
The character data of different size or the same data with a different number cannot be registered.
Set
■
Register the Index and Data settings to the list. When a number that is already registered is selected, it is
overwritten with the new setting.
Insert
■
Insert a character data setting to the selected number in the list.
Click this button to insert the Index and Data setting. The settings at the insertion point shift down 1 line. Settings
cannot be inserted when all numbers are already set.
Delete
■
Delete the selected settings from the list.
Index Device Address
■
Specify the word device for storing the Index No. of the character data matching the received data. You can only
specify an internal device.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-68.
WindO/I-NV4 User's Manual
5 User Communication
3
3-69