IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 962

3 Alarm Log Settings Dialog Box
Auto-Setup Dialog Box and Individual Settings Dialog Box
With the Auto-Setup dialog box, the Alarm Log settings for all channels are batch registered or changed.
With the Individual Settings dialog box, the Alarm Log settings for the selected channel are registered or changed.
*1
Channel
■
Shows the block number and the channel number for the selected channel.
Block Number: Shows the block number for the channel selected in Settings.
Channel Number: Shows the channel number for the channel selected in Settings.
Block Settings
■
Configures Source and Data in block units.
Source: For the Auto-Setup dialog box, the device addresses are sequentially set from block number 1-channel
number 1, starting with the specified device address.
For the Individual Settings dialog box, if Source Device Address Type on the Channel tab is Word,
the 16 channels for the block selected at the start of the specified device address are batch configured.
For Bit, the selected channel is individually configured.
Click
configuration procedure, refer to Chapter 2 "5.1 Device Address Settings" on page 2-68.
Data: Selects whether or not to save Alarm Log data in the date storage area.
For the Auto-Setup dialog box, all the channels are batch configured.
For the Individual Settings dialog box, the 16 channels for the selected block are batch configured.
Store:
No Store: Alarm Log data is not created, but states of device addresses are monitored.
*1 Individual Settings dialog box only
13-18
to open the Tag Editor where you can edit the device address. For the device address
Alarm Log data can be displayed on the MICRO/I or output to file.
WindO/I-NV4 User's Manual