IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 768

8 Alarm Log Display
Options Tab
●
The Options tab is displayed in Advanced mode.
Reference Screen Settings
■
The Options tab is used to configure the reference screen. The reference screen is a base screen or popup screen
associated with each individual message. The reference screen is displayed when the key button Ref. is pressed.
1. Select a message displayed on
the Alarm Log Display
Key bu ons Up and Dwn
Reference Screen:
Coordinates X, Y:
If you overlap the reference screen key button and the move focus key buttons, the reference screen can be
switched and checked while moving the focus.
10-162
REV
Time Message
Up
09:15 Motor fault
Dwn
10:02 Pump1 fault
10:28 High pressure Del
Ref.
13:02 Pump 1 fault
Displays the type of screen selected in Reference Screen on the Channel tab in the Alarm
Log Settings dialog box.
Click to display the Alarm Log Settings dialog box.
When displaying a reference screen, select either Base Screen or Popup Screen as the
reference screen type.
When not displaying a reference, select Not Use.
Specifies the coordinates to display the reference screen.
With the upper-left corner of the screen as the origin, the X and Y coordinates are the upper-left
corner of the reference screen.
This option can only be configured when Base Screen or Popup Screen is selected for
Reference Screen.
Specify the coordinates in 1 dot units.
X: 0 to (base screen horizontal size - 1)
Y: 0 to (base screen vertical size - 1)
WindO/I-NV4 User's Manual
2. Press the key bu on Ref.
REV
Time Message
Up
09:15 Motor fault
Dwn
10:02 Pump1 fault
10:28 High pressure Del
Ref.
13:02 Pump 1 fault
Key bu on Ref.
Reference screen opens
REV
Time Message
Pump 1 fault Pump 1 fault Up
09:15 Motor fault
Pump 1 output low
Dwn
10:02 Pump1 fault
Press Stop, check the air,
10:28 High pressure Del
then press Start.
Air Press.
Ref.
13:02 Pump 1 fault
0000
Stop Start
kg/m 2
Reference screen