IDEC MICRO/I HG4G-CJT22 F-B Series User Manual page 715

• The Change Display Colors check box is selected, Specify Color by Device Address is selected, then the
colors that correspond to the values stored in the device addresses for Specify Color by Device Address and
this device address number+1 are alternately displayed.
Trigger device address
under Flash
Trigger device address
under Flash
Trigger Device Address: Specifies the bit device or the bit number of the word device that will be used to trigger
flash.
Click
Chapter 2 "5.1 Device Address Settings" on page 2-68.
Flash intervals are set in the Flashing Cycle on the System tab in the Project Settings
dialog box.
Text Color: Selects the color (color: 256 colors, monochrome: 16 shades) of text when flashing.
Click this button to display the Color Palette. Select a color from the Color Palette.
This option can only be configured when the Change Display Colors check box is cleared
or selected and Specify Color is selected.
Plate Color: Selects the plate color (color: 256 colors, monochrome: 16 shades) when flashing.
Click this button to display the Color Palette. Select a color from the Color Palette.
This option can only be configured when the Change Display Colors check box is cleared,
or the check box and Specify Color are selected, and Standard is selected for Image
Type on the View tab.
Device Address for
Specify Color by Device Address
Device Address+1
External device
Trigger device
0
1
to display the Tag Editor. For the device address configuration procedure, refer to
WindO/I-NV4 User's Manual
Upper byte Lower byte
0 x 1 6 0 x 1 4
D0=
0 x 2 3 0 x F 7
D1=
MICRO/I
Upper byte
D0
HG SERIES
Plate color
HG SERIES
D1
Plate color
when flashing
5 Message Display
Lower byte
0 x 1 6 0 x 1 4
Text color
Flashing
HG SERIES
HG SERIES
Upper byte Lower byte
0 x 2 3 0 x F 7
Text color
when flashing
10-109
10