Subaru Legacy 2004 Service Manual page 3461

2. Airbag Connector
A: PROCEDURE
1. POWER SUPPLY
1) How to disconnect:
(1) Move the slide lock (A) in the direction of ar-
row.
(2) With the slide lock (A) moved, separate the
connector.
CAUTION:
When pulling the slide lock or disconnecting
the connector, be sure to hold onto the connec-
tor and not the wire.
2) How to connect:
Holding the connector (A), and push it in carefully
until a connecting sound is heard.
CAUTION:
Be sure to insert the connector in until it is
locked. Then pull on it gently to make sure that
it is locked.
Airbag Connector
(A)
AB-00721
AB-00016
2. DRIVER'S AIRBAG MODULE AND PRE-
TENSIONER
1) How to disconnect:
(1) Using a flat tip screwdriver, pry the push
lock upward to unlock.
(2) Pull the connector to disconnect from the
driver's airbag module assembly or retractor as-
sembly.
2) How to connect:
Connect the connector in the reverse order of dis-
connecting. At this time, be sure to insert the push
lock until a connecting sound is heard.
CAUTION:
• Be sure to insert the connector in until it is
locked. Then pull on it gently to make sure that
it is locked.
• Be sure to push the push lock in securely.
NOTE:
Connector can not be connected when the push
lock is in lock position. To connect the connector,
set the push lock to unlock position.
AB-9
AIRBAG SYSTEM
AB-00478
AB-00479
AB-00480