Subaru Legacy 2004 Service Manual page 3347

9. Oil Pump
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the air
IN(H4DOTC)-9, REMOVAL, Air Intake Duct.>
<Ref. to IN(H4SO 2.0)-9, REMOVAL, Air Intake
Duct.>
3) Remove the pulley belt cover.
4) Loosen the belt tension securing bolt and gener-
ator securing bolt, and then remove the power
steering pump V-belt.
5) Disconnect the connector from power steering
pump switch.
6) Disconnect the pressure hose and suction hose
from oil pump.
CAUTION:
• Do not allow fluid to come into contact with
pulley belt.
• To prevent foreign matter from entering the
hose and pipe, cover the open ends with a
clean cloth.
• Non-turbo model
(2)
(1) Suction hose
(2) Pressure hose
intake duct. <Ref.
PS-00461
(1)
PS-00460
Oil Pump
POWER ASSISTED SYSTEM (POWER STEERING)
• Turbo model
to
(1)
(1) Suction hose
(2) Pressure hose
7) Remove the bolts which hold the power steering
pump bracket.
8) Place the oil pump bracket in a vise, and remove
the two bolts from the front side of oil pump.
CAUTION:
When securing the oil pump bracket in a vice,
hold the oil pump bracket with the least possi-
ble force between two wood pieces.
9) Remove the bolt from the rear side of oil pump.
PS-77
(2)
PS-00459
PS-00188
PS-00128