Subaru Legacy 2004 Service Manual page 3884

Hide thumbs Also See for Legacy 2004:

Table of Contents

SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)

2. WAGON MODEL

Check that the wedge of glass lid (front) bracket part is contacting in the direction of vehicle front.

At this time, the lid is at fully open position.

(3) Glass lid (Front)

(4) Glass lid (Rear)

1) Install the motor assembly.

2) After the installation of motor assembly, check again that the wedge of glass lid (front) bracket part is con-

tacting in the direction of vehicle front.

3) Connect the harness connector of motor assembly, and then connect the battery ground cable to battery.

4) Perform the initialize operation of motor.

• When replacing the motor with a new one, fully close the glass once and perform the initialization of posi-

tion, because the movement of glass lid shifts to brink operation.

• When reusing the motor, operate the auto-reverse function five times in a row to shifts brink operation, and

then perform the initialization of position.

5) Check the operation of sunroof with following table.

(1) Glass lid (front) and glass lid (rear) closes completely.

(2) Glass lid (front) tilt up to the ventilating position.

(3) Glass lid (front) tilts up to top position, and glass lid (rear) opens near the completely

open position.

(4) Glass lid (rear) opens completely.

(5) Glass lid (rear) closes on 150 mm (5.91 in) from rear end of tilted up glass lid (front).

(6) Glass lid (rear) closes completely.

(7) Glass lid (front) lowers, and then glass lid (front) and glass lid (rear) closes completely.

6) Install the trim in the reverse order of removal.

Sunroof Motor

Switch position

Chapters

Table of Contents