Subaru Legacy 2004 Service Manual page 3692

WIPER AND WASHER SYSTEMS
8. Front Washer Nozzle
A: REMOVAL
1) Remove the front hood insulator. <Ref. to EB-
13, FRONT HOOD INSULATOR, REMOVAL,
Front Hood.>
2) Hold the pawl of washer nozzle (A) toward the
arrow direction, and remove the washer nozzle.
3) Remove the washer hose from washer nozzle.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Adjust the washer nozzle position. <Ref. to WW-
20, ADJUSTMENT, Front Washer Nozzle.>
C: INSPECTION
• Make sure the nozzle and hose are not clogged.
• Make sure the hose is not bent.
D: ADJUSTMENT
1) Turn the wiper switch to OFF position.
2) While the vehicle is at standstill, adjust the wash-
er injection position as shown in the figure.
Injection position:
A: 250 mm (9.84 in)
B: 435 mm (17.13 in)
(1)
(1) Nozzle
Front Washer Nozzle
(A)
WW-00177
A A
B
WW-00161
Injection angle should be adjusted with 0.5 mm
(0.020 in) thickness steel scale. Use maximum
thickness of 0.5 mm steel scale, because the injec-
tion slit width of washer nozzle is 0.6 mm (0.024 in).
Adjusting with a flat tip driver may damage the in-
jection slit and cause the faulty injection.
(1)
(1) Inside of washer nozzle injection
(2) 0.6 mm (0.024 in)
(3) Steel scale
(4) Max. 0.5 mm (0.020 in)
WW-20
(3)
(2)
(4)
WW-00212