Subaru Legacy 2004 Service Manual page 3680

WIPER AND WASHER SYSTEMS
3. Combination Switch (Wiper)
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover. <Ref.
to EI-50, REMOVAL, Instrument Panel Lower Cov-
er.>
3) Remove the screw to remove steering column
cover (upper and lower).
4) Disconnect the connector from combination
switch.
5) Remove the three screws, and pull out the com-
bination base switch assembly toward you. (EC,
EK, KS and K4 model)
6) Remove the switch securing screw to remove
combination switch.
B: INSTALLATION
Install in the reverse order of removal.
Combination Switch (Wiper)
C: INSPECTION
1. COMBINATION SWITCH
1) Inspect the continuity between each connector
terminal.
SL-00258
• EC, EK, KS and K4 model
LI -00332
WW-8
9 8 7 6 5 4
18 17 16 15 14 13 12
Switch position Terminal No.
OFF
INT
Front LO
HI
Washer ON
Washer ON
OFF
Rear INT
ON
Washer ON
3 2 1
11 10
WW-00046
Standard
Less than 1 "
7 and 16
Less than 1 "
7 and 16
Less than 1 "
7 and 17
Less than 1 "
8 and 17
Less than 1 "
2 and 11
2 and 11
Less than 1 "
12 and 10
2 and 10
— More than 1 M"
Less than 1 "
2 and 13
Less than 1 "
2 and 10
2 and 12
Less than 1 "
12 and 10
2 and 10