Subaru Legacy 2004 Service Manual page 3495

Hide thumbs Also See for Legacy 2004:

Table of Contents

• If any damage, opening or rust is found on the

airbag system wire harness, do not attempt to re-

pair using soldering equipment. Be sure to replace

the faulty harness with a new genuine part.

• Install the wire harness securely with the speci-

fied clips to avoid interference or tangled up with

other parts.

• Do not allow water or oil to come in contact with

the connector terminals. Do not touch the connec-

tor terminals.

• Either of the airbag modules for driver, passen-

ger, side or curtain, or pretensioner must not be

disassembled.

General Description

• The airbag module cannot be used again if once

• After removal, keep the airbag module with the

pad facing upward on a dry, clean and flat surface

away from heat, light sources, moisture and dust.

• Do not check continuity of either of the airbag

modules for driver, passenger, side or curtain, or

pretensioner.

AIRBAG SYSTEM (DIAGNOSTICS)

Chapters

Table of Contents