Subaru Legacy 2004 Service Manual page 3755

9) Apply two types of primers to the adhesive layer
of glass using sponge.
Glass primer:
Betawipe VP04604
Betaprime 5001
10) Apply primer to the adhesive layer of body.
Painted surface primer:
Betaprime 5402
NOTE:
• Primer once attached to the painted surface of
the body and internal trim is hard to wipe off. Mask
the circumference of such area.
• Let primer dry for about ten minutes before in-
stalling the glass.
• Do not touch the surface coated with primer.
(2)
(1) Application of primer
(2) Glass side
(3) Body side
11) Cut off the cartridge nozzle tip as shown and
set it in sealant gun.
(1) 10 mm (0.39 in)
(2) 15 mm (0.59 in)
12) Apply adhesive to the glass end surface as
shown.
Windshield Glass
(1)
(3)
GW-00073
(1)
(2)
GW-00238
Adhesive:
Gurit-ESSEX
Betaseal 1502 or equivalent
(1) 9 — 12 mm (0.35 — 0.47 in)
13) Fit the locating pins using suction rubber cup to
install windshield glass.
14) Lightly press the windshield glass for tight fit.
15) Make flush the adhesive surface jutted out us-
ing spatula.
16) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass and then open/
close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
17) After curing of adhesive, pour the water on ex-
ternal surface of vehicle to check that there are no
water leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
18) Install the cowl panel. <Ref. to EI-39, INSTAL-
LATION, Cowl Panel.>
GW-27
GLASS/WINDOWS/MIRRORS
(1)
GW-00239
GW-00045