Subaru Legacy 2004 Service Manual page 3654

Side Turn Signal Light Assembly
LIGHTING SYSTEM
19.Side Turn Signal Light As-
sembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the scalp caps. <Ref. to GW-17, RE-
PLACEMENT, Scalp Cap.>
3) Remove the mirror. <Ref. to GW-19, REPLACE-
MENT, Outer Mirror.>
4) Disconnect the harness connector, remove the 3
mounting screws and then remove the side turn
signal light assembly.
LI-00293
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Install the side turn signal light assembly and
check that it blinks normally.
2) If it does not blink normally, replace the side turn
signal light assembly with a new one.
NOTE:
Since LED (Light Emitting Diode) is used for side
turn signal light, replace the side turn signal light
assembly when the LED is powered off.
LI-24