Subaru Legacy 2004 Service Manual page 3845

13.CHECK IGNITION SWITCH ILLUMINATION
Step
1 CHECK FUSE.
Remove and visually check the fuse No. 14 (in
the main fuse box).
2 CHECK POWER SUPPLY.
1) Disconnect the ignition switch illumination
harness connector.
2) Measure the voltage between the harness
connector terminal and chassis ground.
Connector & terminal
(B224) No. 2 (+) — Chassis ground (
3 CHECK IGNITION SWITCH ILLUMINATION
CIRCUIT.
1) Disconnect the harness connector of body
integrated unit and ignition switch illumination
harness connector.
2) Measure the resistance between body inte-
grated unit harness connector terminal and
ignition switch illumination harness connector
terminal.
Connector & terminal
(B280) No. 4 — (B224) No. 1:
Keyless Entry System
Check
Is the fuse blown out?
Is the voltage more than 10 V? Go to step 3.
"
):
Is the resistance less than 10
#?
SL-27
SECURITY AND LOCKS
Yes
Replace the fuse Go to step 2.
with a new one.
Check the harness
for open circuits
and shorts
between the igni-
tion switch illumi-
nation and fuse.
Replace the igni- Check the harness
tion switch illumi- for open circuits
nation bulb with a and shorts
new one. <Ref. to between the body
LI-40, REMOVAL, integrated unit and
Ignition Switch Illu- ignition switch illu-
mination.> mination.
No