Subaru Legacy 2004 Service Manual page 3098

10.Warning Light Illumination Pattern
A: INSPECTION
(1)
(5)
(9)
(10)
(12)
(13)
(1) Ignition switch
(2) OFF
(3) ON
(4) Engine start
(5) ABS warning light
(6) Light OFF
1) When warning lights or indicator lights do not illuminate in accordance with this illumination pattern, there
must be an electrical malfunction.
2) When warning lights or indicator lights remain constantly OFF, check the combination meter circuit or CAN
communication circuit. <Ref. to VDC(diag)-26, VDC WARNING LIGHT, VDC OFF INDICATOR LIGHT AND
VDC INDICATOR LIGHT DO NOT COME ON, Warning Light Illumination Pattern.>
3) When ABS warning light does not go off, check the combination meter circuit. <Ref. to VDC(diag)-30, ABS
WARNING LIGHT DOES NOT GO OFF, Warning Light Illumination Pattern.>
4) When the VDC indicator light, VDC warning light and VDC OFF indicator light do not go off, check the com-
bination meter circuit or CAN communication circuit. <Ref. to VDC(diag)-32, VDC INDICATOR LIGHT DOES
NOT GO OFF, Warning Light Illumination Pattern.>
NOTE:
• Even though the ABS warning light does not go off after 1.5 seconds from ABS warning light illumination,
the ABS system operates normally when the warning light goes off while driving at approximately 12 km/h (7
MPH). However, the ABS system does not work while the ABS warning light is illuminated.
• It may take several minutes before VDC warning light and VDC OFF indicator light goes off if the vehicle
is parked under low temperature for a specified time. This is not defective because it is resulted from low en-
gine coolant temperature.
Warning Light Illumination Pattern
(4)
(3)
(2)
(7)
(6) (8)
(7)
(6)
(7)
(6)
(7) Light ON
(8) 1.5 sec.
(9) VDC indicator light
(10) VDC warning light and VDC OFF
indicator light
VDC(diag)-25
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
(3)
(6)
(6)
(11)
(7)
(11)
(12)
(13)
(14)
(6)
(6)
(14)
Several seconds (depending on
engine coolant temperature)
Brake warning light (EBD warning
light)
Parking brake
Released
VDC00214