Subaru Legacy 2004 Service Manual page 3252

Brake Pipe
BRAKE
13.Brake Pipe
A: REMOVAL
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
• All airbag system wiring harness and con-
nectors are colored yellow. Do not use the elec-
trical test equipment on these circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When removing the brake pipe, make sure
that it is not bent.
B: INSTALLATION
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
• All airbag system wiring harness and con-
nectors are colored yellow. Do not use the elec-
trical test equipment on these circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When installing the brake pipe, make sure
that it is not bent.
• After installing the brake pipe and hose,
bleed air.
• After installing the brake hose, make sure
that it does not touch the tire or suspension as-
sembly, etc.
Brake pipe tightening torque:
"
15 N m (1.5 kgf-m, 10.8 ft-lb)
C: INSPECTION
Ensure there are no cracks, breakage or damage
on pipes. Check joints for fluid leakage. If any
cracks, breakage, damage or fluid leakage is
found, repair or replace the pipes.
NOTE:
Use a mirror when inspecting the low-visible part or
backside.
BR-42