Subaru Legacy 2004 Service Manual page 3776

INSTRUMENTATION/DRIVER INFO
2. LIST OF SELF-DIAGNOSIS MODE OPERATION
Speedometer, Microcomputer
tachometer, fuel running type
gauge, water warning light,
temperature indicator light
gauge
Step 0. Processing to self-diagnosis mode
Operating initial Initial illuminat-
operation ing
Step 1-1. Check each indication after initial operation
Repeat the Light ON
sweep opera-
tion (After hold-
ing on lowest
position for one
second, reaches
to highest posi-
tion within 5
seconds, and
after holding on
highest position
for one second,
reaches to low-
est position
within 5 sec-
onds).
Step 1-2. Press the trip knob (trip knob input is not accepted till the meter indicator needle reaches the highest position): sweep
complete, AT select lever position indicator display is set
After complet- Light ON
ing sweep in
step 1-1, back to
lowest position.
Step 2-1. Press the trip knob, and hold it: Check each meter
All meters are Light OFF
moved simulta-
neously in every
0.5 sec. from
the lowest posi-
tion to highest
position.
Speedometer/
Tachometer:
Approx. 5
degrees at
every move-
ment.
Water tempera-
ture gauge/Fuel
gauge: Approx.
2 degrees at
every move-
ment.
Step 2-2. Release the trip knob: Specifying the meter directing position
Stop at direct- Light OFF
ing position
when the trip
knob is
released.
Step 3-1. Press the trip knob, and hold it: Check illumination
Combination Meter System
AT select lever Odo/Trip indica-
position indica- tor
tor light
Normal Normal
With the high- Perform the seg-
est brightness, ment check. For
illuminate the the illumination
position sequen- order, refer to
tially at a cycle the illumination
of 1.5 seconds. order table.
Keep the posi- Underbar " _ " is
tion indicated displayed.
when the trip
knob is pressed.
Keep the posi- Display the cur-
tion indicated rent meter
that set in step directing angle
1-2. on odometer.
Ex.) Display
"135054" when
Speedometer/
Tachometer:
135 degree,
Water tempera-
ture gauge/Fuel
gauge: 54
degree.
Keep the posi- Display the cur-
tion indicated rent meter
that specified at directing angle
step 1-2. on odometer.
IDI-4
SPORT shift Illumination
indicator (indicator nee-
dle, plate, ring,
LCD)
Initial illuminat- Initial illuminat-
ing ing
Perform the seg- Light at the
ment check. For highest bright-
the illumination ness.
order, refer to
the illumination
order table.
"1" is displayed. Light at the
highest bright-
ness.
"M2" is dis- Light at the
played. highest bright-
ness.
"2" is displayed. Light at the
highest bright-
ness.
Buzzer (SPORT
shift buzzer,
speed warning
buzzer)
Not beep.
Not beep.
Not beep.
Not beep.
Not beep.