Subaru Legacy 2004 Service Manual page 3632

LIGHTING SYSTEM
1. General Description
A: SPECIFICATION
Headlight
Front turn signal light
Clearance/parking light
Front fog light
Side turn signal light
Rear combination light
Back-up light
License plate light
Rear fog light
High-mounted stop light
Interior light
Spot map light
Luggage room light
Trunk room light
Glove box light
Door step light
B: CAUTION
• Before removing or installing parts, always dis-
connect the battery ground cable from battery.
When replacing the audio, control module and oth-
er parts provided with memory functions, record the
memory contents before disconnecting the battery
ground cable. Otherwise, the memory will be
erased.
• Reassemble the parts in the reverse order of dis-
assembly procedure unless otherwise indicated.
• Adjust parts to the given specifications.
• Connect the connectors securely during reas-
sembly.
C: PREPARATION TOOL
1. GENERAL TOOL
TOOL NAME
Circuit tester
General Description
Halogen type low beam
Halogen type high beam
Tail/stop light (Model with
rear fog light)
Tail light (Model without rear
Sedan
fog light)
Stop light (Model without
rear fog light)
Wagon Tail/stop light
Turn signal light
Sedan
Wagon
Sedan
Wagon
Sedan
Wagon
• After reassembly, make sure functional parts op-
erate smoothly.
WARNING:
• The air bag system wiring harness is routed
near electrical parts and switches. All air bag
system wiring harnesses and connectors are
yellow. Do not use the electrical test equipment
on these circuits.
• Be careful not to damage the air bag system
wiring harness when servicing electrical parts
and switches.
Used for measuring resistance and voltage.
LI-2
12 V — 55 W
12 V — 60 W
12 V — 21 W
12 V — 5 W
12 V — 55 W
12 V — 2.7 W (LED)
12 V — 5/21 W
12 V — 5/21 W
12 V — 21 W
12 V — 5/21 W
12 V — 21 W
12 V — 16 W
12 V — 21 W
12 V — 5 W
12 V — 21 W
12 V — 2 W (LED)
12 V — 21 W
12 V — 1.3 W (LED)
12 V — 8 W
12 V — 8 W
12 V — 13 W
12 V — 5 W
12 V — 1.4 W
12 V — 3.5 W
REMARKS