Subaru Legacy 2004 Service Manual page 3814

SEATS
NOTE:
Armrest cannot be removed when backrest assem-
bly RH side does not mate with armrest side pin po-
sition.
6) After this operation, refer to the step 2) to disas-
semble backrest assembly RH.
7) Remove the hook, and then remove the armrest
cover.
8) Remove the hook and hog ring, and then re-
move the headrest cover.
9) Remove the hog rings (A) on the rear side of
seat cushion.
Rear Seat
10) Remove the hog rings (A), and then remove the
seat cushion cover.
D: ASSEMBLY
1. SEDAN MODEL
Assemble in the reverse order of disassembly.
NOTE:
SE-00356
• Do not contaminate or damage the cover.
• While installing the hog rings, prevent the seat
from getting wrinkled.
CAUTION:
• Always use new hog rings.
• Secure the hog ring using hog ring pliers.
• Install the hog rings to the specified points
securely and be sure to prevent backrest cover
from wrinkle or twisting.
2. WAGON MODEL
Assemble in the reverse order of disassembly.
SE-00357
NOTE:
• Do not contaminate or damage the cover.
• While installing the hog rings, prevent the seat
from getting wrinkled.
CAUTION:
• Always use new hog rings.
• Secure the hog ring using hog ring pliers.
• Install the hog rings to the specified points
securely and be sure to prevent backrest cover
from wrinkle or twisting.
E: INSPECTION
: (A)
Check that no tear or fray on the seat cover.
SE-00399
SE-18
: (A)
SE-00398