Subaru Legacy 2004 Service Manual page 3740

GLASS/WINDOWS/MIRRORS
5) To adjust the upper end and lower end of center
pillar, loosen the stopper bolt (A) or nut (B) securing
door sash, move the stopper position until the
clearance between center pillar cover is equal.
CAUTION:
Perform the measurement of clearance be-
tween center pillar at less than 50 mm (1.969 in)
from upper end of window glass.
(1)
(1) Glass
(2) Center pillar cover
(3) Check point
(4) 50 mm (1.969 in)
(5) 11 mm (0.433 in)
Front Door Glass
(A)
GW-00320
(B)
GW-00321
(2)
(5)
(4)
(3)
GW-00322
GW-12
6) Adjust so that the upper and lower ends of cen-
ter pillar are the same size.
(5)
(5)
(1) Narrow
(2) Wide
(3) Glass tilts too far rearward
(4) Glass tilts too far forward
(5) Stopper adjusting direction
(1)
(3)
(2)
(5)
(2)
(4)
(1)
(5)
GW-00323