Subaru Legacy 2004 Service Manual page 3626

SEAT BELT SYSTEM
CAUTION:
• After deployment, the pretensioner is espe-
cially hot, leave it unattended for 40 minutes or
longer, and then discard it.
• Do not let water get on the deployed preten-
sioner.
11) Remove the front outer belt. <Ref. to SB-12,
REMOVAL, Front Seat Belt.>
12) Cut off the seat belt as close to retractor as pos-
sible.
13) Wrap the deployed pretensioner in airtight vinyl
bag, and discard it.
2. DEPLOYING OF PRETENSIONER AF-
TER REMOVAL FROM VEHICLE
1) Fold the backrest all the way forward, and then
move the front seat all the way forward.
2) Turn the ignition switch to OFF, disconnect the
battery ground terminal, and wait more than 20
seconds.
3) Remove the front outer belt. <Ref. to SB-12, RE-
MOVAL, Front Seat Belt.>
Disposal of Pretensioner
4) Cut off the seat belt as close to retractor as pos-
sible.
5) Short the terminal to alligator clip of deployment
tool.
6) Connect the deployment tool (A) and deploy-
ment adapter D (B).
CAUTION:
The terminals of deployment tool should be
kept shorted until just before deployment of the
SB-00130
pretensioner.
SB-00131
7) Connect the deployment adapter D connector
and pretensioner connector.
8) Install the pretensioner on a wheel with tire.
Then, bundle three automotive wire harness [each
with a sectional area of 1.25 mm
more], and bind them twofold around the preten-
sioner bracket and wheel.
SB-18
(A)
(B)
(A) Deployment tool:
(Tool number 98299PA030)
(B) Deployment adapter D:
(Tool number 98299SA010)
SB-00130
SB-00021
2
(0.00194 sq in) or
SB-00024