Subaru Legacy 2004 Service Manual page 3056

VEHICLE DYNAMICS CONTROL (VDC)
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST24082AA230
ST22771AA030
2. GENERAL TOOL
TOOL NAME
Circuit tester
Pressure gauge
Oscilloscope
General Description
TOOL NUMBER DESCRIPTION
24082AA230 CARTRIDGE
22771AA030 SUBARU SELECT
MONITOR KIT
VDC-6
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
Troubleshooting for electrical system.
Troubleshooting for electrical system.
• English: 22771AA030 (Without printer)
• German: 22771AA070 (Without printer)
• French: 22771AA080 (Without printer)
• Spanish: 22771AA090 (Without printer)
REMARKS
Used for measuring resistance, voltage and ampere.
Used for measuring oil pressure.
Used for measuring sensor.
REMARKS