Subaru Legacy 2004 Service Manual page 3321

13) Remove the holder using a 36 mm spanner or
adjustable wrench.
14) Install the ST on valve side of rack and press
outer side oil seal out taking care not to contact
rack with steering body inner surface.
ST 34199FE010 INSTALLER & REMOVER
(Turbo and 3.0 R model)
ST 34199FA030 INSTALLER & REMOVER
(Except for turbo and 3.0 R
model)
NOTE:
Block the pipe connection of steering body to pre-
vent fluid from flowing out.
(1) Rack piston
(2) Outer side oil seal
Steering Gearbox [RHD Model]
PS-00498
PS-00064
PS-51
POWER ASSISTED SYSTEM (POWER STEERING)
15) Insert the ST from the valve side and press the
back-up ring and oil seal out.
ST 34199FE010 REMOVER (Turbo and 3.0 R
model)
ST 927580000 REMOVER (Except for turbo
and 3.0 R model)
PS-00065